EN
CLEANING AND MAINTENANCE
WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Clean the blades with the supplied brush after each use.
We recommend oiling the blades after every other use. Apply several drops of oil to the teeth, and switch on
the unit to work the oil between the blades.
Don't use hair oil, petroleum or oil containing solvents to lubricate the blades. These can slow the movement
of blades when they dry.
The surface of the unit may only be cleaned using a wet cloth. Don't use any detergents or hard objects as
they may damage the unit's surface!
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
The protective cover should be put on the blades after cleaning.
TROUBLESHOOTING
Problem
Motor does not run.
The blades do not cut
properly.
ACCUMULATOR DISPOSAL
The appliance contains an Ni-MH accumulator. This accumulator type contains substances that may damage
the environment when decomposing. Prior to the appliance disposal or the accumulator replacement,
remove the original accumulator and take it to a designated collection yard.
WARNING!
Never throw the accumulator into a fire!
36
Cause
Plug inserted into the
mains outlet incorrectly or
insufficiently.
The mains outlet is not live.
The supply cable is damaged.
The blades are not set or oiled
well, or they are blunt.
Solution
Check the plug connection.
Check for voltage, e.g. by connecting another
appliance.
Refer the unit to an authorized service center for
testing and repair.
Disconnect the cable from the socket. Check
the setting of blades and oil them. If the quality
of the cut does not improve, the blades are blunt
and you need to replace them.
ZA 7010