Concept ZA 7010 Bedienungsanleitung Seite 35

OPERATING INSTRUCTIONS
The unit is designed to cut hair and beards..
CUTTING
1. Sit the person in front of you on a chair, so that the person's head is at the level of your chest.
2. Cover the person's neck and shoulders to protect against falling hair.
3. Brush the hair.
4. Switch on the appliance.
5. Cut the hair, applying slow repeated movements. Always cut small sections of hair. We recommend
starting with a higher blade guard, then using the lower ones.
6. The length of the cut can be adjusted slightly using the cut height adjustment lever (Fig. 5).
7. For easier cutting of longer and curly hair you may use a comb against the blades. Remove the cut hair to
prevent clogging of the mechanism.
8. To cut the hair around the ears and on the nape of the neck, remove the blade guard.
9. Before you cut the ear line, comb the hair over the ears. To straighten the line on the nape of the neck,
turn the mechanism vertically to the skin, and create a clean line, using slow movements (Figs. 6-8).
10. When putting down the unit during use, always switch it off.
11. Switch the unit off after use.
12. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect
it from the wall outlet, as the proximity of water or any contact of the unit with water is very dangerous,
even when the unit is switched off!
Switch the unit off when changing the blade guards!
CUTTING OVER A COMB OR THE FINGERS
This technique requires certain skill; use it when you want a cut longer than 12 mm.
1. Use the unit without the blade guard.
2. Comb a small lock of hair upwards, hold it using a comb or the fingers.
3. Cut the hair that overhangs the fingers or the comb. Comb frequently to remove cut hair.
ZA 7010
EN
35