Important Safety Instructions - Hedson IRT UV SPOTCURE Bedienung- & Ersatzteile-Handbuch

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical equipment, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING IRT UV
SPOTCURE
WARNING
UV RADIATION CAN CAUSE PERSONAL INJURY AND
PROPERTY DAMAGE!
UV EMITTED FROM THIS PRODUCT. SKIN OR EYE
INJURY COULD RESULT. AVOID EXPOSURE OF EYES
AND SKIN TO UNSHIELDED LAMP.
Summary of results from RISE Research Institutes of
Sweden AB
Depending on the distance from the UV-dryer, the limit
value according to AFS 2009:7 index b. (UVA eye) for
one working day (8 h) is reached after one or a few
minutes at close distances (0,5–1 m). At longer distances
than about 3 m, the acceptable exposure time is an hour
or more.
To reduce risk of injury, or property damage from UV
radiation, read, understand, and follow the following
safety instructions. In addition, make certain that anyone
else that uses this curing equipment follows these safety
instructions as well.
• Always wear eye protection. Failure to this may result
in long term injury to the eyes.
• Wear protective clothing. Hands, face and other
parts of the body shall not be exposed to heat and
radiation. Do not stay in front of the lamp cassettes
during curing without safety equipment.
• If a person works around UV radiation while on
medications, the medication should be checked to
see if it would make the person more photosensitive.
• Do not look directly at the light source.
SAVE THESE INSTRUCTIONS
715065 rev 4
WARNING
To reduce the risk of fire, electric shock, or injury:
• Do not leave equipment when plugged in. Unplug
from outlet when not in use and before servicing.
• Do not allow to be used as a toy.
• Use only as described in this manual. Use only
manufacturer's recommended attachments.
• Do not use with damaged cord or plug. If equipment
is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, return
it to a service center.
• Do not pull or carry by cord, use cord as a handle,
close a door on cord, or pull cord around sharp edges
or corners. Keep cord away from heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
• Do not handle plug or equipment with wet hands.
• Turn off all controls before unplugging.
• Do not store, prepare or use solvent-containing
materials within a 5 m/16 feet radius of the dryer.
• Flammable materials should not be placed close to a
curing device in use.
• Never direct the cassette towards highly combustible
materials.
• The dryer must not be exposed to paint fog, sanding
dust or solvents, due to fire and explosion risk
Furthermore, the lifetime of the dryer will otherwise
be reduced.
• The dryer is operated by highly dangerous electrical
voltage.
• Before accessing live parts, remove the main
connector from the wall socket. Only professional
electricians may have direct access into the electrical
equipment.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• This product should only be used with the filter glass
intact.
• As appropriate measures; Always wear eye protection
during work in areas exposed to UV-radiation. Make
sure to always work in a well-ventilated environment.
• The curing device users must adhere to these
operating instructions. This appliance is not intended
for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Do not use in wet or moisture conditions.
EN 3