Dell PowerConnect W-AP120 Installationsanleitung Seite 8

Connecting a Security Cable
To provide added security for the W-AP121 or W-AP125, you can attach a security cable to the back of the unit
(see Figure
Figure 8
Verifying Post-Installation Connectivity
The integrated LEDs on the AP can be used at this point to verify that the AP is receiving power and initializing
successfully (see
installation network connectivity.
Table 3
LED
PWR
ENET 0
(100/1000 Mbps)
ENET 1
(100/1000 Mbps)
11A/N
11B/G/N
Configuring the W-AP120 Series
AP Provisioning/Reprovisioning
Provisioning parameters are unique to each AP. These local AP parameters are initially configured on the
controller which are then pushed out to the AP and stored on the AP itself. Dell recommends that provisioning
settings be configured via the ArubaOS Web UI only. Refer to the ArubaOS User Guide for complete details.
8
8).
Security Lock Connection
Table 3). Refer to the ArubaOS Quick Start Guide for further details on verifying post-
Color/State
Green steady
Green flashing
Red steady
Green/Amber off
Green on
Amber on
Green/amber blinking
Green/Amber off
Green on
Amber on
Green/amber blinking
Amber
Green
Amber
Green
Meaning
Power on, device ready
System initializing
System failed to initialize, contact TAC
No link
1000 Mbps link
100 Mbps link
Data activity
No Link
1000 Mbps link
100 Mbps link
Data activity
Wireless link is legacy 11a
Wireless link is 11n 5 Ghz band
Wireless link is legacy 11b or 11g
Wireless link is 11n 2.4 Ghz band
Dell PowerConnect W-AP120 Series AP | Installation Guide