Dell PowerConnect W-AP120 Installationsanleitung Seite 4

Installing the AP
Note: Service to all Dell products should be performed by trained service personnel only.
Using the Integrated Wall-Mounting Slots
The keyhole-shaped slots on the back of the AP can be used to attach the device upright to an indoor wall or shelf.
When you choose the mounting location, allow additional space at the right of the unit for cables.
Note: For product dimensions, see
of the installed unit for cables, and make sure enough space is available for antenna articulation.
1. At the mounting location, install two screw on the wall or shelf, 1 7/8 inches (4.7 cm) apart. If you are
attaching the device to drywall, Dell recommends using appropriate wall anchors (not included).
2. Align the mounting slots on the rear of the AP over the screws and slide the unit into place (see
Figure 2
3. On the W-AP121 or W-AP125, orient the antennas. For best performance, swivel the antennas so that they
are oriented vertically, preferably in the same plane, parallel to the wall (see
Figure 3
On the W-AP120 or W-AP124, install the external antennas according to the manufacturer's instructions,
and connect the antennas to the antenna interfaces on the AP (see
4
Product Specifications
Installing the W-AP120 Series Access Point on a Wall
Antenna Orientation on a Wall-Mounted W-AP121/W-AP125
in this guide. Allow 2 inches (5 cm) of additional space at the right side
Figure
Dell PowerConnect W-AP120 Series AP | Installation Guide
Figure
Figure 3).
4).
2).