Electrolux TG 092 Benutzerinformation Seite 61

Problem
The appliance
does not cool
sufficiently
The appliance cools
too hard
The appliance
does not cool at
all
The appliance is
noisy
Green indicator
flashing
Inasmuch as the advice does not lead to result, call the nearest brand-mark
service.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm
indicator will start to flash. The product will continue to operate with the use of a
reserve system until the problem is eliminated by the local service personnel.
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was
not precooled sufficiently.
Large-sized food was put in.
Too many foods to be frozen were
put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too
high.
Plug is not connected to the mains
socket properly.
There is no voltage in the mains
socket.
Thermostat set to "0" position.
The appliance is not supported
properly.
Temperature sensor problem.
GB
Solution
Set higher position.
Pre-cool the appliance for
enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max.
temperature.
Check if the door is shut.
Set lower position.
Check if the connection is
proper.
Check if there is voltage.
Check thermostat setting.
Check if the appliance stands
stable (all the four feet should be
on the floor).
Call the service personnel.
electrolux 61
at room