Stability Leg; Focus; Magnification; Image Freeze And Image Save - Vision Engineering CamZ Bedienungsanleitung

OPERATION

Stability Leg

X
The CamZ is provided with a flip out leg located
around the lens on the underside. Simply flip it out
fully to help maintain the ideal distance from the item
you are viewing. Click it back in place when not in use.

Focus

X
There are two preset focal distances, near and far, set at approximately 12mm and 24mm from
the base of the unit. These distances cannot be changed as they are integral to the dimensioning
function of the device. A short press of

Magnification

X
Repeatedly pressing the
choose the level that best suits what you are viewing.

Image freeze and Image Save

X
A short press of the
live image.
X
While the image is frozen, a long press of the
memory. When the image is stored you will automatically enter the Image Recall mode described below.

Image Recall

X
From the live image, a long press of
be shown and a picture number, in the form "# 10" for example, will be displayed. Use
to move to the previous and next stored images.

Deleting Saved Images

X
When in Image Recall mode (above) you can delete the currently displayed image by a long press
of the button. The unit will show a trash can icon with a "?" beside it, asking you to confirm
deletion. Another long press of

Dimensioning Cursors and Grids

X
Repeated short presses of
finally clear the lines. The dimensions between the lines will be displayed on the screen. Note
the accuracy of this grid is dependant on how well focussed the unit is. The grid spacing will
automatically adjust to represent 1mm when the zoom or focus distance is changed on the unit. In
many cases it will be useful to freeze the image with the
If the image is saved while the grids or cursors are displayed, they too will be saved on the image.
CamZ handheld digital magnifier
2
will toggle between near and far focus.
button will cycle through the three levels of magnification. You can
button will freeze the image. Another short press of
will enter the image recall mode. The last stored image will
will delete the image and display the prior saved image if it exists.
will first display the 1mm grid, then the dimensioning cursors and
button will save the frozen image to the internal
will return to the live camera mode.
button before adjusting the cursors/grid.
www.visioneng.com/support
will return to the
and