Operation; Initial Operation; Switching On/Off - Vision Engineering CamZ Bedienungsanleitung

Operation

Initial operation

X
We recommend you fully charge your CamZ magnifier before its first use. The charger is supplied
with a range of international power connectors and you should choose the appropriate one for your
country.
X
Fit the cable to the charger and plug it into the end of the handle on the CamZ (A). The charging
indicator around the power connector will illuminate in orange as the CamZ is charging and will
extinguish when charging is complete. A full charge takes about 3 hours but can be longer.
X
Alternatively, the CamZ can be charged from the USB port of a computer or by many standard
chargers for portable consumer devices. The connector used is an industry standard and all such
chargers should be compatible though charging times may vary considerably. For best results, the
CamZ should not be operated while charging.
X
The unit is supplied with a neck strap that can be fitted to the end of the handle (B) if required.

Switching on/off

X
Slide the power switch (C) forwards to turn on the unit. The LED lights on the underside will illuminate
and an image will appear on the screen. Place the unit over the item you want to magnify with the
screen centred over the area of interest. You will need to raise or lower the unit to find the sharpest
focus. The CamZ will re-use your last magnification and focus settings when next powered on.
www.visioneng.com/support
Short press
Cycle grids and cursors
Image freeze
Focus near/far
Magnification level
CamZ handheld digital magnifier
OPERATION
Long press
Cursor Adjust/LED bright
Recall mode
LED alternate flash
Illumination mode
1