Installing The Bike Mount; Fitting The Gps Device In The Bike Mount - Silvercrest SFN 1.5 A1 Bedienungsanleitung Und Serviceinformationen

Battery charge display
A battery symbol consisting of a number of bars appears on the display (2) while your GPS
device is charging. The number of bars indicates the battery charge level:
battery fully charged. You can disconnect the device from the computer.
battery 2/3 charged.
battery 1/3 charged.
battery empty. It takes about 5 hours to charge the battery completely.

Installing the bike mount

You can fit the GPS device to the handlebar of your bike. This allows you to operate it at any time
and keep your eye on the display (2).

Fitting the GPS device in the bike mount

1. Place the back of the GPS holder on the front of the handlebar
mount ("cross to cross"). Make sure you hold the handlebar
mount so that the semicircular insert for the handlebar is
aligned horizontally, like the handlebar, and guide 2 of the
8 cable ties through the square holes at the top and bottom
through the handlebar mount (see diagram on the right).
The cable ties need to be fed through the handlebar mount
to make sure the GPS holder and the handlebar mount are
firmly fixed together.
Keep the remaining cable ties in a safe place. You can use
them if you want to fix the handlebar mount to a different
bike.
If you cannot feed the cable ties through both components, the GPS holder
is fitted to the handlebar mount rotated by 90°. The unlock lever on the GPS
holder should be parallel to the cable ties.
80
GPS Outdoor Computer SFN 1.5 A1
English