Motion Detection - Anlapus Poe Nvr System Anleitung

6 Video Record
Right click mouse > Go to Main Menu > Setup > Record
You shall see the record settings for all channels. Change the record setting according to your preference and apply
the changes.

6.1 Motion Detection

Set motion Detection,NVR will record only when motion or movement is detected. Right click mouse > Main Menu >
Setup > Alarm > Motion > Motion detection.
The system starts recording when motion is detected by the camera, and the monitoring picture will show at the
bottom left corner.
Note: if your system has preinstalled hard disk, please skip this step.
Select Camera. Tick the Channel you want to record on motion detection.
Area: It is allowed to set sensitivity area of camera viewing range.
11