Anlapus PoE NVR System Anleitung Seite 10

⑥ Unplug RJ-45 cable from the added camera, and connect it to another wifi camera, then do it as
step 3 to step 6 as above.
5 Install a Hard Disk
The system may not include Hard Disk, it's depending on the kit you selected. This system works with
most 3.5" SATA Hard Disk or 2.5" SATA Hard Disk.
Note: if your system has preinstalled hard disk, please skip this step.
① Unplug your NVR from power, unscrew and remove the top cover.
② Connect the SATA power and data cables from the NVR to the corresponding ports on your hard
disk as shown.
③ Place the hard disk into the NVR. Any cable should cross up over the hard disk.
④ Holding the hard disk and the NVR, gently turn it over and line up the holes on the hard disk
with the holes on the NVR. Using a Phillips screwdriver, screw the provided screws into the holes.
Assemble the cover.
Note:
After installing a hard disk, you need to first format the Hard Disk before recording.
Right click the mouse > go to Main Menu > Disk Management > Select the Hard Disk > Click Format >
Apply.
① ②
③ ④
10