Extremis EXTEMPORE Montageanleitung Seite 7

6. Drill holes (Ø 12 mm) in the ground at the marked
spots. The depth of the drill holes must correspond to
the size of the plugs. They may not protrude above the
ground.
8. Now put the legs of the table or the bench over the
protruding stainless steel axles.
7. Screw down the supplied stainless steel axles with
coach screws. Make sure that the stainless steel axles
are perfectly straight.
9. Tighten the little screws at the bottom of each leg.
english 7