Assembly and Operation
WARNING For Charging
· Use only the original external adaptor and provided charging cable.
· Make sure the robot and the charger port are clean and dry before set-up.
· Make sure that the robot is turned off by sliding the switch to OFF position prior to charging.
· Fully charge the robot (about 5-6 hrs) before using it for the first time.
· Power indicator light : No light - Power off / no power
Light - Power on
Blinking light - Battery power will cease within 10 minutes.
Note:
Once the robot begins charging, the indicator light on the external adaptor will turn red. When the robot is almost fully charged, the indicator light will turn green.
1
5
6
2
4
Left
7
8
8.4
Note:
Pry to detach the float cover and release the rope from the float to the depth of pool water plus about 0.5m(19.7in.).
303021219102_58482_21x28.5cm_ 英
2
Fixed locking pin
Left
Right
Factory setting of the pin for all types
of pool.
8.1
8.5
3
Right
If the robot trajectory is too curved,
pull out the pin and insert it in this
hole. Make sure the wheel axle is
positioned below the axle.
8.2
4
4
To increase the curve of the trajectory,
remove the pin from the hole and
insert it in the hole which is located
above the pin hole as shown.
8.3
8.6