Overview; Additional Menu Items - Sony PDBK-103 Installationsanleitung

Overview

Additional Menu Items

16 Overview
The PDBK-103 Analog HD Input Board (called "this board" in the
following) is an option board for installation in the Sony PDW-F70/
70MD/F75/75MD Professional Disc Recorder.
The principal features of this board are as follows.
Installation of this board in the PDW-F70/70MD/F75/75MD enables
you to input analog HD component signals (SMPTE 274M compatible)
and to record them on XDCAM HD discs.
This board supports YPbPr signals and RGB signals. When an external
sync input signal is present, it synchronizes to the external sync input
signal.
Note
This board must be installed in option slot 2 of the PDW-F70/70MD/
F75/75MD. You can install one board in option slot 2, either this board
(the PDBK-103), the PDBK-102, or the PDBK-104.
Installation of this board requires an upgrade to the firmware of the disc recorder. For
details, contact your Sony dealer or a Sony service representative.
Note
Always verify that the unit is operating properly before use. SONY
WILL NOT BE LIABLE FOR DAMAGES OF ANY KIND
INCLUDING, BUT NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE LOSS OF PRESENT
OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT,
EITHER DURING THE WARRANTY PERIOD OR AFTER
EXPIRATION OF THE WARRANTY, OR FOR ANY OTHER
REASON WHATSOEVER.
When this board is installed in the PDW-F70/70MD/F75/75MD, the
underlined items in the following table appear in the HOME page of the
function menu.
Refer to Chapter 6 "Menus" in the Operating Instructions (PDW-F70/F75) /
Instructions for Use (PDW-70MD/75MD) for more information about function menu
operations.