DJI TAKYON Updater Bedienungsanleitung Seite 5

3. Select an appropriate battery to power the ESC. Do not
disconnect it from your computer or the battery until
configuration is complete.
4. Launch DJI Assistant 2. When a connection is established,
the software will display connected devices.
5. Click under "Connected Devices" to enter the settings page
and configure the ESC.
6. Click on the top left of
page. Check the current firmware version and ensure the
installed firmware is up-to-date. If not, login with your DJI
account and click the Upgrade button.
If your ESC is not recognized by DJI Assistant 2 (no
connected devices):
Check if there is more than one FTDI device connected
such as another Takyon Updater, a DJI Updater, an FTDI
USB adapter or development board (e.g. a BeagleBone,
Raspberry or Arduino board). Unplug other FTDI devices,
restart the ESC and DJI Assistant 2, and try again.
Re-connect the ESC and the power supply in the
following order: Connect the ESC to your computer,
connect the power supply to the ESC, and then launch
DJI Assistant 2.
6
to enter the firmware upgrade