Inhaltsverzeichnis
Werbung
ATTACHMENTS
Ensure that the device is switched off before fitting or removing attachments.
TO FIT AND REMOVE BLADES
•
To remove, pull the blade upwards out of the body of the device.
•
To fit, position the blade as desired (fig. A) then insert it into the opening and press it
downwards until it clicks into place.
•
The T-blade and micro detail blade can be positioned facing upwards or downwards to
help you trim difficult to reach areas.
FITTING AND REMOVING FIXED/ADJUSTABLE COMBS
To Fit
•
Hook the front of the guide comb over the teeth of the T-blade (Fig B).
•
Press the back of the guide comb down until it clicks into place.
To Remove
•
Lift the tab on the back of the guide comb upwards until it comes free from the
T-blade.
INSTRUCTIONS FOR USE
•
Comb facial hair with a fine comb before you start trimming.
•
Comb your hair in the direction that it grows so that the hairs are at their maximum
height and facing in the same direction.
•
Since all hairs do not grow in the same direction, you may want to try different
trimming positions (i.e. upwards, downwards or across) for better results.
•
Hair should be dry and free from any waxes or lotions.
•
If hair builds up during use, switch the unit off, remove any attachment in use and
clean any excess hair clippings from the attachment and groomer.
BEARD STYLING AND MAINTENANCE
1.
Fit the T-blade and desired comb.
2.
Use the dial on the adjustable comb, or select a fixed comb for the desired length
setting.
3.
Start trimming under the chin following the line of the jaw.
4.
Work upwards towards the ear and upper beard line.
5.
Tidy the beard edges using the precision T-blade or micro detail blade.
•
Note: Use the beard trimmer without the combs for trimming hair close to the skin.
This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to
0.4mm.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5
Werbung
Inhaltsverzeichnis
