Remote Control - Sulion Handair 72643 Bedienungsanleitung

Remote control

3
2
1
EN
1H 4H 8H
Syncing the receiver and the remote control for fan operation
If the receiver and transmitter of this fan are properly synchronized, the fan will work. During
synchronization the receiver recognizes the signal from the transmitter, this is called the lear-
ning process.
Make sure the fan is disconnected. This is essential for the synchronization process.
Unless the synchronization process has been successful, the fan will work partially or will not
work. By default, all fans have been preconfigured at the factory and should be functional once
the installation is completed and the fan is turned on.
If the remote control does not work after installation or during use, synchronization can be
performed as indicated below. Note in any case that there could be other reasons why your
fan or remote control does not work:
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
Instructions for synchronizing the receiver and the remote control
The fan control does not require synchronization with the receiver. Communication is univer-
sal with the receivers of this model.
The fans installed in the same operating area respond to the same control.
14
4
5