Installation; Operating Features - urmet 1092/276HA Schnellanleitung

ENGLISH

INSTALLATION

•
Make sure that no units are powered before starting the installation procedure.
•
Unscrew the fixing base from the ring lock to separate the camera, as in figure.
•
Fix the base to the surface with 2 screws. If it is not planned an hidden installation of connection
cables, use the slot present on the base to draw out the connection cables present on the camera
body, without pinching them, in order to avoid malfunction.
•
Bring the cover near the fixing base and screw the ring lock to the fixing base without tightening.
•
Adjust the camera slant as regards the desired image capture point.
•
Connect the video output to the utility.
•
Power the camera.

OPERATING FEATURES

PUSH BUTTON TO ACCESS
TO THE MENU ALONG THE
CAMERA CABLE
TO SELECT THE VIDEO OUTPUT
The 1092/276HA camera may use 4 different video outputs, which are on the same BNC connector:
•
High-definition 1080P AHD (Analog High Definition) video output
•
High-definition 720P AHD (Analog High Definition) video output
•
CVBS standard interlaced video output
•
Video output in COMET mode
DS1092-351A
Mount fixing screw
Camera body
Protective
dome
LEFT
UP
RIGHT
SET
DOWN
5