Suavinex care Gebrauchsanweisungen Seite 29

2. PARTS OF THE HUMIDIFIER
A. Lid
B. Essential oil tray
C. Water tank
D. Control button
E. Base
3. INSTRUCTIONS FOR USE
BEFORE USING THE APPLIANCE FOR THE FIRST TIME, IT IS IMPORTANT TO KNOW THAT:
- The humidifier should be used in an environment between 5 and 45ºC with a relative humidity of less than 80%.
- Use water (we recommend using mineral water) at room temperature (below 40ºC) to fill the tank.
- While in operation, the humidifier will stop working if the tank (C) is removed from its base (E). If the tank is put
back on its base, it will be necessary to switch the humidifier on again.
To start using the appliance follow these steps:
1- Take the water tank (C) by removing it from its base (E) and remove the lid (A).
2- Add water to the tank (C) without exceeding the MAX mark on the inside. If you want the humidifier to run for
8 hours, fill it up to the MAX mark. (FIG. A).
3- Place the base on the humidifier (E) on a flat, rigid, stable surface. Note that the power supply cable is
positioned on the rim of the base (FIG. B).
4- Place the water tank (C) (with water inside it) on the base (E).
5- Put the lid on the humidifier (A), fitting it into the groove in the water tank (C) (FIG. C).
6- Point the mist outlets (F) in the desired direction.
7- Plug the power supply cable (I) into the mains.
Fig A Fig B
F. Mist outlet
G. Diffuser
H. Steam
generation unit
I. Power supply cable
Fig C
THE FOLLOWiNg TABLE SHOWS YOu THE FuNCTiONS OF THE APPLiANCE DEPENDiNg ON
WHETHER OR NOT YOu uSE THE APP:
Control the power at two levels: maximum and minimum
Check the percentage of humidity and temperature of the room
Control the percentage of humidity in the room
Control the colour and intensity of the Night light
Programme the on/off timer of the humidifier
Programme the on/off timer of the night light
3.1. OPERATION WITHOUT THE LINK APPLiCATiON
®
To use it without the App follow these steps:
1- Keep the button (D) pressed for three seconds. You will hear two short beeps and the corresponding blue
light will come on and the humidifier will start to run at maximum power.
2- To change to the minimum power level press the button (D) again. At that moment you will hear a beep and the
light will change from blue to purple. Every time you want to change level, from maximum to minimum and vice
versa, you can do so with a short press of the button (D). Every time you press the button a beep will sound and
the light will change colour according to whether maximum power (blue) or minimum power (purple) is selected.
3- To switch off the humidifier, keep the button (D) pressed for three seconds. At that moment you will hear two
short beeps, the light will switch off and the humidifier will stop working.
· NOTE:
-The mist outlets can be touched while the humidifier is in use. There is no risk of burns because it generates
cold vapour.
- When the tank (C) of the humidifier runs out of water, the light on the button (D) will start to flash red and
an intermittent beep will sound. To stop this, press the button (D) for 3 seconds to switch off the appliance,
otherwise it will switch off automatically after 3 minutes. To refill the tank follow the steps explained in section
section 3. INSTRUCTIONS FOR USE
3.2. OPERATION WITH THE LINK APPLiCATiON
®
In order to use the humidifier with the App you will need to configure your WIFI connection.
To do this, follow these steps:
1- Enable the WIFI connection on your smartphone.
2- Open the Suavinex Link® application.
3- Go to the "devices" tab of the app. All the Suavinex products will appear under this tab.
4- After selecting the humidifier, follow the instructions in the app.
5- Once you have configured the WIFI connection, you can enjoy using the humidifier with the Suavinex
application.
You can now enjoy using the humidifier with the Suavinex Link® application. Now follow the instructions on the
application to use the humidifier.
· NOTE:
- If the whole WIFI configuration process takes more than 5 minutes, the appliance will switch off automatically.
- The humidifier will save the last operating mode programmed from the app in which it was running before it was
switched off.
- If you wish to switch off the appliance while the humidifier is operating via the application, you can also do so
manually by pressing the button (D) for 3 seconds.
· imPORTANT:
- The warning on the appliance about lack of water in the tank will be disabled in this case:
· When the humidifier is operating via the application, a notification will be shown in the app.
EN - 55
WiTHOuT WiTH
THE APP THE APP