Tweeter Installation - Radical Audio RA162.3 Bedienungsanleitung

TWEETER INSTALLATION

The tweeter units come with two different mounting adaptors, suitable for flat sur-
face of flush mounting. After you have checked which tweeter location in your
vehicle offers best staging and smooth midrange reproduction, you can attempt to
install the tweeters:
Fig.: Flat Surface Mounting
Flat Surface Mounting
a Using the flat bayonet lock base as a template, mark the two screw holes and
drill them by using a 3 mm drill bit. Secondly, mark and drill the 6 mm hole for
the tweeter lead wire to get through the panel.
s Mount the flat tweeter adapter base to the panel using the two self-tapping
screws provided with the mounting hardware set.
d Run the speaker wire included in the speaker wire kit from the crossover to
the flat adapter base. Connect the tweeter main wire to the wire extension
coming from the crossover.
f Mount the main tweeter unit to the flat base by inserting the tweeter into the
conical mounting ring. Place this unit over the adaptor base, turning the
ring clockwise. This locks the tweeter unit in place.
8