Fine Tuning Of Tweeter Level - Radical Audio RA162.3 Bedienungsanleitung

FINE TUNING OF TWEETER LEVEL

a The tweeter level can be set to four different attenuation levels, to
compensate for different mounting locations of the tweeters and - of course -
to suit personal taste.
s Slide back the transparent cover of the crossover unit and set the preferred
attenuation level by adjusting the jumper on the circuit board.
d Caution: Both tweeter attenuation jumpers must be set to identical
positions! The tweeter level is set best, after the installation is complete with
all the additional components you intend to install, like subwoofer, amplifier(s)
etc. The tweeter level balance should be entirely played by ear. For this final
adjustment, make sure the following steps have been carried out:
z
Highpass and lowpass frequency adjustment settings of the electronic
crossovers
z
Input gain level adjustment of satellite and subwoofer channels
(if applicable)
z
Tone controls - including the loudness function - set to neutral /
zero position.
Fig.: Jumperposition
10