Crossover Wiring - Radical Audio RA162.3 Bedienungsanleitung

CROSSOVER WIRING

a Wire the crossover unit as shown in the schematic diagram below. Be sure
to maintain speaker polarity at the input/output terminals of the crossover!
s The transparent cover of the x-over housing can be pushed back to gain
access to the screw mounting holes and the jumper for tweeter attenuation
inside the housing. For tweeter level adjustments, see chapter "FINE TUNING
OF TWEETER LEVEL", page 9.
d Fix the crossover in place with the provided self-tapping screws - avoiding the
exposure of the crossovers to water, excess humidity or other fluids.
f Later on, when the best tweeter locations have been determined, the tweeter
level can be fine tuned by a jumper located inside the crossover housing.
Therefore the crossovers must remain accessible!
Fig.: Crossover Wiring
7