Technical Data; Installation - Leonard LK1201 Benutzerhandbuch

Replacing the lamp
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension of the recess
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
1. Disconnect the mains plug from the
2. Remove the screw from the lamp cov-
3. Remove the lamp cover (refer to the il-
4. Replace the used lamp with a new
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
8. Open the door. Make sure that the
3. If necessary, replace the defective door
Height
Width
Depth
Climate
class
SN
N
ST
T
mains socket.
er.
lustration).
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
socket.
lamp comes on.
gaskets. Contact the Service Center.
1225 mm
560 mm
550 mm
230-240 V
50 Hz
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
leonard 17