Striale ST-714 Bedienungsanleitung Seite 10

2. Assembling right upright tube
Put signal wire (30) through Right upright tube (5) and Insert Right
upright tube(5) to the base frame (13) with two sets of Half-round bolts
M8X16(A2), Flat washers φ8(C1) in the front and one set of Half-round
bolt M8X45 (A1), Flat washer φ8(C1) at the side. Do not tighten the
bolts. (See figure 2)
3. Assembling left/right upright tube and computer/handlebar
a. Connect the signal wire (30) with the wire comes out from the
computer/handlebar (10). (see figure3)
b. Tighten the computer (10) to the Left & right support tube (4, 5)
with four Bolts M8X16 (A16). (see figure3)
c. At last, tighten all the bolts from step 1 and step 2.
D
Fixierungen und Werkzeug