Test Run - Mitsubishi Electric Jet Towel JT-SB216JSH-W-NE Bedienungsanleitung

Test Run

Step
1
Check the power supply voltage
2 Turn the ground-fault circuit
interrupter on
3 Turn the power switch "ON".
4 Insert your hands to check if air is
being blown.
5
Insert your hands to check if warm
air is being blown.
(Only with the JT-SB216JSH type
when the heater is "ON".)
(The JT-SB216KSN model does not
have a heater)
6
※ Do not turn the power on while hands or other objects are inside the hand drying area.
※ If the display lamp fl ashes, turn the power switch "OFF", check that all of the lamps on the display section are off, and
then wait for 1 minute before switching the power back "ON".
Is single-phase 220-240V power being used?
Incorrect power supply may cause malfunctions.
Is the power lamp in the display on?
Is the air blowing?
Is warm air blowing?
( If the room temperature is above 30ºC, for safety reasons
the heater will not operate even if the heater switch is
turned on.）
※ As the heater is a simple heater, if the room temperature
is less than 18ºC, the air may feel cold.
Is the heater lamp in the display on?
Is the appliance mounted securely without any vibration or
abnormal noises?
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
AUTHORIZED REPRESENTATIVE IN EU:
MITSUBISHI ELECTRIC EUROPE B.V.
HARMAN HOUSE, 1 GEORGE STREET, UXBRIDGE, MIDDLESEX UB8 1QQ, U.K.
What to check for
− 11 −
Check