Nilox F-60 Bedienungsanleitung Seite 3

The remote controller has three function keys and one red indicator that blinks when a key is pressed:
-Green key: video camera starts
-Dark grey key: photo camera starts
-Light grey key: stop
Photo camera/ Remote controller pairing
To match the functions of the remote controller with those of F-60 video camera, perform the following operations:
-Turn off the video camera and press the red STOP key
- Turn on the video camera
- Release the Stop key within 5 seconds and press the green and the light grey keys on the remote controller at the same time
After successful code pairing, F-60 video camera generates a tick tone twice.
OUTPUT INTERFACES
F-60 Photo camera has 2 audio video output interfaces:
-Av, Hdmi
And one data files output:
-Usb
Video Out
You can connect the photo camera to a video interface, through the AV output, by using the cable supplied.
Once connected, the video camera can perform all its functions.
The display or the TV, connected to the video camera, works exactly like the TFT display of the video camera.
Usb Interface
The USB connection allows to:
-Give power supply to F-60 video camera
- Connect the video camera to a computer in order to read the data in its memory and micro SD card.
INSTALLATION AND USE OF A BACKUP BATTERY
F-60 photo camera can use a backup battery to be installed in place of the TFT display
You can install the battery for the power supply without setting any parameter. You only need to remove the TFT display and replace it with the
backup battery, as shown in the following figure:
PRECAUTIONS
Precautions for the waterproof case
The waterproof case is a precision component. Please use the following precautions:
•
Do not randomly dismount and mount the O-ring of the case, keys and lens cover without assistance, otherwise the waterproof
performance deteriorates.
•
Do not put the case in a place where corrosive gases are easily generated due to the existence of strong acid or alkali and keep it away
from chemical or corrosive substances.
•
Do not store the product in a place where temperature is too high (over 50°C) or low (-10°C) for a long time to avoid deformation.
•
Do not expose it to direct sunlight for a long time to avoid deterioration of the waterproof performance.
•
Before the use, ensure that the O-ring is intact, the seal is litter-free, the case is fully sealed and the buckle is tight.
•
After using the case in sea water, wash it using fresh water, clean it and dry it in a cool place.
4