elem Garden Technic TTAC58T43R-CC196 Übersetzung Der Originalanleitung Seite 63

Spark Plug Service
For good performance, the spark plug must be properly gapped and free of deposits.
Disconnect the spark plug cap and remove any dirt from around the spark plug area.
Remove the spark plug with a spark plug wrench.
Inspect the spark plug. Replace it if the electrodes are worn, or if the insulator is cracked or chipped.
Measure the spark plug electrode gap with a suitable gauge. The gap should be 0.028 ~ 0.031 in (0.7 ~
0.8mm). Correct the gap, if necessary, by carefully bending the side
electrode with a suitable tool.
Install the spark plug carefully, by hand, to avoid cross-threading.
Install the spark plug cap on the spark plug.
STORAGE
The same petrol must not remain in the tank for more than one month.
Thoroughly clean the mower and store it indoors in a dry place.
Never store the lawnmower with fuel in the tank inside a building where can reach an open flame or
spark.
To reduce fire hazard, keep the engine, muffler, battery compartment and fuel storage area free of grass,
leaves or excessive grease.
If the fuel tank has to be drained, this should be done outdoors.
Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blade
and fixed parts of the machine.
Allow the product to cool for at least 30 minutes before storing.
63