Firmware Upgrade - Philips EXP431 Bedienungsanleitung

General information

Firmware upgrade

Occasionally, Philips releases new software ("firmware") for your set.
1
Connect the mains adapter to 4.5V DC on the set and to the wall socket
(see "Mains adapter").
2
Keep MODE pressed for 3 seconds.
➜
The type of your set and the current version
of the firmware are displayed. Upgrade? is
displayed.
Press 9.
3
4
Visit the Philips Audio homepage www.audio.philips.com. Check if there
is a firmware file for your set and if the firmware version is higher than
the current version of your set. Download the file and burn it on an
8 cm CD-ROM.
5
Insert the CD-ROM into the set and keep MODE pressed for 3 seconds.
➜ Upgrade? is displayed.
Press 2;:
6
➜ Upgrading is displayed and upgrading starts.This may take some minutes.
After upgrading is finished, Upgrade complete is scrolled.
➜ Wrong upgrade file is scrolled:Your set already has the latest firmware
or the downloaded file does not correspond to your set.
➜ Upgrade file defect is scrolled:The upgrade file has been damaged
during the download or when burning the CD-ROM. Download the file
again, burn a new CD-ROM and try again.
➜ No upgrade file is scrolled: No upgrade file was found on the inserted
CD-ROM.
Note: If upgrading is interrupted accidentally, repeat steps 5 and 6 until upgrading
is completed successfully.
12