Environment - Zanussi ZTBB 276 Benutzerinformation

lowest point of the hose and to place a small
container below it. (See picture, point B).
Once connected to the dryer, run the vent hose
to the desired outlet point, ensuring that the
run's overall length is less than 2 m, and that it
contains no more than two bends. As to the
outlet itself, if you have decided on a fixed wall/
window grille, a good local builder's merchant
should be able to supply you with the necessary
fittings and installation advice.
Warning!
It is important not to
connect the vent hose
to, for example, a
cooker hood, or a
chimney or flue pipe
designed to carry the
exhaust from a fuel
burning appliance.
Note that to avoid con-
densation problems, it is essential that the dryer
be fitted with the flexible hose to carry its "ex-
haust" at least beyond the kitchen units; pref-
erable outside the kitchen. In order to prevent
the appliance from overheating, it is important
that the steam exhaust is unobstructed. There-
fore, in case of a permanent hose fitted to an
exterior wall or ceiling, it must be ensured an ex-
haust capacity of at least 150 m3/h. If the dryer
is fitted next to kitchen units, make sure that the
vent hose is not squashed. If the hose is partial-
ly squashed, drying efficiency will be reduced,
resulting in longer drying times and higher ener-
gy consumption. If the hose is completely
squashed, the safety cut-outs with which the
machine is fitted may operate. When operating
the tumble dryer, the room temperature must
not be lower than +5°C and higher than +35°C,
as it may affect the performance of the appli-
ance.

Environment

Recycle the materials with the symbol
the packaging in applicable containers to
recycle it.
46
Electrical connection
Details on mains voltage, type of current and the
fuses required should be taken from the type
plate. The type plate is fitted near the loading
aperture (see "Product description" chapter).
Connect the machine to an earthed sock-
et, in accordance with current wiring regu-
lations.
Warning! The manufacturer declines
any responsibility for damage or
injury through failure to comply with the
above safety precautions.
Should the appliance power supply cable
need to be replaced, this must be carried
out by our Service Center.
Warning! The plug must be accessible
after installing the machine.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed. The door must only
be reversed by an authorised service engineer.
Please contact your local Service Force Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
Stacking kit
A special stacking kit is
available through your
dealer, to enable the
mounting of the dyer on
top of a front loading
washing machine with
cover's depth between
48 and 60 cm. Read
carefully the instruc-
tions supplied with the kit.
. Put Help protect the environment and human health
and to recycle waste of electrical and electronic
appliances. Do not dispose appliances marked
with the symbol with the household waste.
www.zanussi.com