Installation - Zanussi ZTBB 276 Benutzerinformation

Installation

Appliance positioning
• It is recommended that, for your convenience,
the machine is positioned close to your wash-
ing machine.
• The tumble dryer must be installed in a clean
place, where dirt does not build up.
• Air must be able to circulate freely all round
the appliance. Do not obstruct the front venti-
lation grille or the air intake grilles at the back
of the machine.
• To keep vibration and noise to a minimum
when the dryer is in use, it should be placed
on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or low-
er the feet until it is.
• The feet must never be removed. Do not re-
strict the floor clearance through deeppile
carpets, strips of wood or similar. This might
cause heat built-up which would interfere
with the operation of the appliance.
Important! The hot air emitted by the tumble
dryer can reach temperatures of up to 60°C.
The appliance must therefore not be installed on
floors which are not resistant to high
temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C and
higher than +35°C, as it may affect the
performance of the appliance.
Warning! Should the appliance be moved,
it must be transported vertically.
Warning! The appliance must not be
installed behind the lockable door, a sliding
door or a door with a hinge on the opposite side
to that of the appliance.
Removing transport safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
www.zanussi.com
1. Open loading door.
2. Pull off adhesive
strips from inside ma-
chine on top of drum.
Fitting the vent hose
To simplify the installation, there is a choice of
vent outlets: one at the back, the others in the
left and right-hand side. Connect the hose to
whichever is the more convenient by pulling the
ring nut (A) from the vent outlet at the back,
screwing it on to the hose and pushing it firmly
back into place. The unused vents should now
be sealed with the special snap covers provi-
ded.
A
If the hose is long and
the room temperature
low, the moisture might
condense to water
inside the hose. This is
an unavoidable natural
phenomenon. To
prevent this water from
Iying in the hose or
flowing back into the tumble dryer, it is
advisable to drill a small hole (via. 3 mm) in the
3. Remove foil hose
and polystyrene pad-
ding from the ma-
chine.
A
B
45