Machine Settings - Zanussi ZTBB 276 Benutzerinformation

Problem
Loading door does not close.
Drying cycle ends shortly after pro-
gramme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends auto-
matically.
1) Only dryers with conductance programming
2) Only dryers with removable filter

Machine settings

Setting
Buzzer permanent off
www.zanussi.com
Possible cause
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
1)
ting of machine.
2)
Filter not in place .
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the
compressor to avoid overload.
1. Turn the programme selector to any programme.
2. Press simultaneously the LAGE TEMP. (DELICATE ) and ANTI-
KREUK / EINDE (LONG ANTICREASE ) buttons and hold down
for approx. 5 seconds.
3. The buzzer is by default always off.
Clean fluff filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting
for degree of drying (see 'Machine
settings' chapter)
Install filter into place
Select time programme or higher
drying level (e.g. EXTRA DROOG
(EXTRA DRY) instead of KAST-
DROOG (STORAGE DRY) ).
Clean filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no
fault with the appliance. If possible,
lower the room temperature.
Implementation
Remedy
1)
.
2)
.
43