Behringer C210 Bedienungsanleitung Seite 18

18 C210
C210 Getting started
(EN)
Step 3: Getting
started
Place the speaker in your
desired location.
Set all controls as shown:
TREBLE and BASS knobs to
their centered position at
12 o'clock; LEVEL 1, LEVEL 2,
LINE/INST LEVEL and MASTER set to their
minimum levels at the full
counter-clockwise position.
Make all necessary
connections. DO NOT turn on
the power yet.
Turn on your audio sources
(mixer, microphones,
instruments).
Turn on your speaker(s) by
pressing the POWER switch.
The PWR LED will light up.
Insert your USB device or
SD/MMC flash memory card
with digital audio files into
their respective USB or
SD/MMC connections.
Using the controls in the DSP
section, choose a digital audio
file from your USB stick or
SD/MMC card and begin
playback by pressing the PLAY
PAUSE button.
Turn the LEVEL control up to
around the 50% position.
Make overall volume
adjustments using the
MASTER knob.
Play your analog audio
sources, or speak into your
microphone at a normal to
loud level.
Balance the analog signals
against the digital audio
playback by adjusting the
LEVEL knob and the volume
knobs on each analog channel. If an analog
signal distorts, turn that analog channel's
volume knob back down.
If necessary, adjust the HIGH and LOW
EQ knobs to boost or cut treble and bass
frequencies to your taste.