Gewiss 20 Serie Bedienungsanleitung Seite 16

6. TAMPER PROTECTION ON THE BASE
Moving the microswitch lever to install the sensor in a corner:
1 = Remove the microswitch activator lever by unhooking it from the rotation pin as indicated in A in the top right
drawing.
2 = Remove the plastic closing dowel from the corner of the sensor as shown in B.
3 = Rotate the lever to 180° and insert the tip of the side fixing slot fastening it firmly to pin C.
NOTE = The tab that acts on the removal protection microswitch must not be enabled when the joint is assembled,
it is therefore necessary to switch selector 1 "REMOVAL PROTECTION EXCLUSION" to ON (see connection
drawing).
7. RANGE OF COVERAGE DRAWINGS
Standard lens
Range coverage drawing of the supplied lens with white light protection.
Range: 15 metres
TOP VIEW
A
B
Coverage: movement, 81° open field 15 m
180°
Band layout: 18 zones covering 4 floors
SIDE VIEW
TOP VIEW
MINIMUM RANGE COVERAGE
16
180°
C
SIDE VIEW
GW 20 477