Connecting To The Speaker System - TAD -M1000 Bedienungsanleitung

Connecting to the speaker system

CAUTION
' The input terminals of speaker systems have a negative (–) pole and a positive (+) pole. Make sure to align these poles
correctly when connecting to the speaker terminals of this unit.
' Make sure to use speakers with an impedance of 4 Ω to 16 Ω.
' Use speaker cables with a large electrical capacity and make sure no warps or shorts are present. Using speaker
cables with a small electrical capacity or making imperfect connections could affect the sound quality of your
speakers or cause abnormal heating and shortage.
' Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the
bare speaker wire touches the back panel it may cause the power to cut off as a safety measure.
' These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or
disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts.
How to connect the speaker system
Connect the positive (+) terminal of the speaker system to the positive (+) terminal of this unit.
Connect the negative (–) terminal of the speaker system to the negative (–) terminal of this unit.
Connecting the speaker cable
1. Remove 15 mm (9/16 in.) of the protective insulation to the speaker cable, and twist the core wires together.
2. Turn the speaker terminal knob to the left. (
The terminal knob will slide out and create a gap.
3. Insert the speaker wire into the gap and turn the terminal knob to the right to tighten. (
1
15 mm (1/10 in.)
12
)
2
Speaker
terminal
Terminal knob
Y lug terminal
Y lug terminals may also be connected (refer to your
plug's operation manual for further information).
)
3
Speaker cable