SCOPREGA GE BP Anleitung Seite 8

WARNING!
EN
Read all instructions carefully before operating the inflator. Failure to follow all instructions listed
below may result in product damage and/or serious injury.
WARNINGS:
1. Read these instructions.
2. Keep these instructions.
3. Follow all instructions.
4. Protect the cord from being walked on or damaged.
5. Refer all servicing to qualified service personnel. Servicing is required when the product has
been damaged in any way.
6. Do not disassemble product. Incorrect reassembly may result in a risk of short circuit.
7. Provide adequate ventilation and refrain from placing items on or around the inflator during
operation.
8. Do not block the inlet port.
9. Since the vibrations produced by the inflator may cause it to "walk", do not operate on a high
shelf and keep movements under control.
10. The use of different adapters than the ones supplied with the inflator may damage the pro-
duct.
11. Keep this product out of the reach of children.
DO NOT SUPPLY THE INFLATOR AT A HIGHER VOLTAGE THAN THE NOMINAL VOLTAGE.
GENERAL SAFETY RULES
1. CONSIDER WORK AREA ENVIRONMENT.
Don't expose the inflator to rain. Don't use in presence of flammable liquids or gases.
2. AVOID UNINTENTIONAL STARTING.
Don't start the inflator with the inlet port in contact with dust or water.
3. STAY ALERT.
Watch what you are doing. Use common sense.
4. CHECK DAMAGED PARTS.
Before further use of the inflator, any damaged part should be carefully checked to determine that it will
operate properly and perform its intended function.
5. DO NOT OPERATE the inflator near flammable liquids or in gaseous or explosive atmospheres. The motors
in this inflator normally sparks and the sparks might ignite fumes.
6. WARNING! DO NOT INHALE.
The compressed air from your inflator is not safe for breathing. Never inhale air from your inflator or from
a breathing device connected to the inflator.
7. WARNING! RISK OF BURSTING.
Inflate items only to their manufacturer's recommendations. Over-inflation could cause them to explode
resulting in personal injury.
8. DO NOT LEAVE THE UNIT RUNNING UNATTENDED.
Over-inflation could result in serious injury and property damage.
9. WARNING! RISK OF UNSAFE OPERATION.
Do not modify or attempt to repair. Never drill into or make any modifications to the inflator or its accesso-
ries.
10. WARNING! FIRE RISK.
Let the inflator cool down for 20 minutes after an operation time of 10 minutes maximum. Overheating
may damage the product.
11. Never carry the inflator by the hose or by the power cord.