Napoleon BILEX 485 Handbuch Seite 18

18
BILEX485 BUILT-IN INSTRUCTIONS
EN
x6
N570-0073 (1/4-20 X 3/8")
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified
installer to local codes.
1. Attach side mounting brackets to each side of the grill using #1/4-20 x 3/8" screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each
wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex
supply line to the fitting at the end of the manifold.
4. The entire installation must be leak tested before operating the unit.
www.napoleongrills.com
Install battery's as illustrated. Plug wire from LED (lights) located underneath
control panel into wire from battery pack. Ensure wires do not come in contact
with the bottom of the grill. The battery pack module must be mounted inside
the enclosure, at least 20cm below the bottom of the drippan, to prevent the
module from overheating. Ensure wires and module do not interfere with
drippan removal.
10mm
N415-0271CE-GB-DE OCT 23.17