Operator Maintenance; Environmental Conditions - Cole Parmer MCS-102L Bedienungsanleitung

Guarantee
The unit is guaranteed against any defect in material or workmanship for the period specified on the
enclosed guarantee card. This period is from the date of purchase, and within this period all
defective parts will be replaced free of charge provided that the defect is not the result of misuse,
accident or negligence. Servicing under this guarantee should be obtained from the supplier.
Notwithstanding the description and specification(s) of the units contained in the Operator's Manual,
Techne hereby reserves the right to make such changes as it sees fit to the units or to any
component of the units.
This Manual has been prepared solely for the convenience of Techne customers and nothing in this
Instruction Book shall be taken as a warranty, condition or representation concerning the description,
merchantability, fitness for purpose or otherwise of the units or components.

Operator maintenance

NOTE: THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED BY PROPERLY TRAINED
PERSONNEL.
REMOVING THE SIDE, FRONT OR REAR PANELS EXPOSES POTENTIALLY LETHAL MAINS
VOLTAGES.
THERE ARE NO OPERATOR MAINTAINABLE PARTS WITHIN THE EQUIPMENT.
In the unlikely event that you experience any problems with your unit which cannot easily be
remedied, you should contact your supplier and return the unit if necessary. Please include any
details of the fault observed and remember to return the unit in its original packing. Techne accept
no responsibility for damage to units which are not properly packed for shipping: if in doubt, contact
your supplier. See the Decontamination Certificate supplied with your unit.
1.Cleaning
Your unit can be cleaned by wiping with a damp soapy cloth. Care should be exercised to prevent
water from running inside the unit. Do not use abrasive cleaners.
2.Fuses
Your unit is protected by two fuses. These should only be changed by suitably qualified personnel.
If the fuses blow persistently, a serious fault is indicated and you may need to return the unit to
your supplier for repair.

Environmental Conditions

The unit is designed to operate under the following conditions:
• Indoor use
• Ambient temperature range +5ºC to +40ºC
• Altitude to 2000m
• Relative humidity up to 95%
• Mains supply fluctuations not exceeding 10%
• Over voltage category II IEC 60364-4-443
• Pollution degree 2
• Use with a minimum distance all-around of 200mm from walls or other items
Note: The control specifications are quoted at an ambient temperature of 20ºC. The specification may
deteriorate outside an ambient temperature of between 10ºC and 30ºC.
The unit has been tested for radio frequency interference and is certified under EN61326.
4