Sub-Zero PRO 48 Bedienungs- Und Pflegeanleitung Seite 9

S U B - Z E R O P R O 4 8 U S E & C A R E
I C E M A K E R O N / O F F
The ICE M KER key pad on the control
panel switches power to the ice maker system
on or off. Use the ICE M KER
to shut down ice maker operation during
extended vacations. The ice bucket icon will be
visible in the exterior temperature display if
the ice maker system is on.
A L A R M F E AT U R E
The PRO 48 has an alarm feature that lets you
know with an audible beep if a door or drawer
is left ajar. The alarm will sound after 30
seconds if a door or drawer is left open and
will stop once the door or drawer is closed.
This alarm can be disabled for cleaning or
restocking by depressing the
pad on the control panel.
E X T E R I O R T E M P E R AT U R E D I S P L AY
Electronic control system functions, such as
digital temperatures and service indicators, are
displayed in two exterior temperature displays
located on the grille. The display in the lower
left area of the grille shows the temperature
and indicators for freezer compartments, and
the display in the lower right gives readouts
for refrigerator compartments.
PRO 48 exterior temperature display
V I S U A L S E R V I C E D I S P L AY
The electronic control system monitors
compartment and component temperatures as
key pad well as the ice maker system. If there is a
temperature or ice maker problem, you will be
alerted by a flashing SERVICE indicator light in
the exterior temperature display. This same
SERVICE light will also flash if the condenser
needs cleaning.
S A B B AT H M O D E ( S TA R - K )
The PRO 48 features Sabbath Mode for certain
religious observances where lights and the ice
maker need to be turned off.
To initiate Sabbath Mode while the unit is on,
press the POWER
L RM key
panel so that OFF is visible in the exterior
temperature display. Then press and hold the
POWER
turn the unit back on with lights and ice maker
disabled. There will be four short beeps, indi-
cating that the Sabbath Mode has been set. To
return the unit to normal operation, press and
release the POWER
If you have questions about Star-K compliance,
visit www.star-k.org.
key pad on the control
key pad for 10 seconds. This will
key pad.
9