Troubleshooting Guide - Sub-Zero PRO 48 Bedienungs- Und Pflegeanleitung

T R O U B L E S H O OT I N G
F R E Q U E N T LY A S K E D
T E M P E R AT U R E
IMPORT NT NOTE: Unless the unit is being
serviced, make sure the power for your unit
is on. If the unit is not on, OFF will be visible
in the exterior temperature display. Use the
POWER key pad on the control panel to
turn on power to the unit.
Q: How do I adjust the temperatures in my
unit?
: To adjust temperatures, refer to
Temperature Control, page 8.
Q: What are the suggested temperature
settings?
: The recommended settings are 3°C for
refrigerator compartments and -18°C for
freezer compartments.
Q: Condensation is forming on the inside
and outside of my unit.
: In climates with higher humidity, conden-
sation will form and is considered
normal. Leaving the door open for a long
period of time may also contribute to
condensation forming on the inside your
unit.
Q: My unit isn't cooling properly.
: Clean the condenser area as outlined on
page 15.
N O I S E
Q: Why do I hear my unit running
constantly?
: It is normal to hear the operation of fans
and motors from the product. Sounds will
be accentuated based on the placement
of the unit and overall room design.
G U I D E
Q U E S T I O N S
I C E P R O D U C T I O N
IMPORT NT NOTE: Make sure that the ice
maker system is on. The ice bucket icon will
be visible in the exterior temperature display
if the ice maker system is on. If it is not on,
use the ICE M KER
control panel to turn on power to the ice
maker system.
IMPORT NT NOTE: Dispose of the first
bucket of ice produced by your new unit to
ensure that pipe residue or other particles
associated with new water lines are not
consumed.
Q: My ice maker isn't producing very much
ice.
: On average, you can expect a cycle of ice
(eight cubes per cycle) every two hours.
Q: My ice is freezing together and clumping.
: If ice is not used regularly it tends to fuse
together. You may need to discard the ice
and allow ice to be replenished.
D O O R O P E R AT I O N
Q: Why is my door hard to open?
: Your unit was designed for an airtight
seal. vacuum seal can form after the
door is closed. Wait several seconds for
pressure to equalize before reopening the
door.
Q: The door on my unit is opening too fast
and hitting the wall or surrounding
cabinets.
: The unit may not be leveled properly or a
door stop may be required. Contact your
Sub-Zero dealer for details on the door
stop kit.
key pad on the
17