Sub-Zero PRO 48 Bedienungs- Und Pflegeanleitung Seite 15

S U B - Z E R O P R O 4 8 U S E A N D C A R E
I N T E R I O R C L E A N I N G
To clean interior surfaces and removable parts,
wash with a mild solution of soap and luke-
warm water with a little baking soda. Do not
use vinegar. Rinse and dry thoroughly. void
getting water on lights and control panel.
Do not submerge or pour hot water over
cold glass shelves.
E X T E R I O R C L E A N I N G
To clean the exterior of the classic stainless
steel finish, use a soft, nonabrasive stainless
steel cleaner and apply with a soft 100% lint-
free cloth.
To bring out the natural luster, lightly wipe the
surface with a water-dampened microfiber
cloth followed by a dry polishing chamois. ll
work should follow the grain direction of the
finish. Better results are obtained by keeping
the cloth in continuous contact with the stain-
less steel.
Under no circumstances should you use a
metallic or highly abrasive cleaner or
cloth, as this will scratch the classic
stainless steel finish.
C O N D E N S E R C L E A N I N G
The condenser of the PRO 48 is located behind
the grille at the top of the unit. The grille must
be lifted to access the condenser area for
cleaning. To lift the grille, pull out on the
bottom edge of the grille and tilt the grille
frame forward.
Use a soft bristle brush and vacuum to remove
dust and lint from the condenser. Clean the
condenser area every three to six months.
Failure to clean the condenser could
result in temperature loss or mechanical
failure or damage.
Before cleaning the unit, shut the electric-
ity off at the control panel. When you
clean the condenser, wear gloves to avoid
injury from the sharp condenser fins.
15