Candy CDSN L Bedienungsanleitung Seite 93

"START DELAY" button
The dishwasher start time can be set with
this button, delaying the start by 3, 6 or 9
hours.
Proceed as follows to set a delayed start:
l
Choose a programme by pressing the
"PROGRAMME SELECTION" button.
l
Press the "START DELAY" button (each
time the button is pressed the start will be
delayed by 3, 6 or 9 hours respectively,
and the corresponding time indicator light
will switch on).
l
To start the countdown, press the
"Start/Reset" button
indicator light will start to flash).
If a 9 hour delay is set, countdown will be
displayed by the 6h indicator light after 3
hours and the 3h indicator light after 6
hours.
At the end of the last 3 hours (at the end of
countdown) the 3h indicator light will stop
flashing and remain on to indicate the
washing phase and the programme will
start automatically.
If countdown has not ended, whereby the
programme has not yet started, it is
possible to change or cancel the delayed
start and select another programme or to
select/deselect the
proceeding as follows:
l
Hold the "Start/Reset" button down for at
least 3 seconds. Some audible signals
will sound and the programme indicator
lights will turn on and off individually and
sequentially.
l
The delayed start and the selected
programme will
programme indicator lights will flash, the
dishwasher is ready start Programme.
(the set time
option button,
be cancelled. The
Activation/Muted END-OF-
PROGRAMME signal.
You can deactivate turning on and off of the
audio signal as follows (the default setting is
active):
l
Turn on the dishwasher by pressing the
"ON/OFF" button for about 3 sec.
l
Hold down the "Progr." and "ON/OFF"
buttons for about 5 sec.
l
All the indicator lights will flash for 5 sec.
- If the audio signal is active, the
"Express" indicator light will be on.
- If the audio signal is not active, the
"Express" indicator light will be off.
1. Press the "Express" button to turn the
audio signal on or off.
2. Whenever the audio signal is turned on,
in addition to visual confirmation given by
turning on the "Express" led, an acoustic
signal will sound as confirmation.
3. If you turn off the audio signal, no audio
signal will sound to accompany the
visual confirmation when the "Express"
led goes off.
4. Turn off the dishwasher by holding down
the "ON/OFF" button for about 3 sec. to
make the new setting effective.
MEMO FUNCTION (Memorising
the last programme used)
Proceed as follows to enable storage of the
last programme used in memory:
l
Turn on the dishwasher by pressing the
"ON/OFF" button for about 3 sec.
l
Hold down the "Progr." and "ON/OFF"
buttons for about 5 sec.
l
All the indicator lights will flash for 5 sec.
93