Water Demineralisation; Partial Demineralisation Cartridges With Flow Meter; Full Demineralisation Cartridges With Conductivity Meter - Miele UG 70-60/80 Gebrauchsanweisung

Partial deminerali-
sation cartridges
with flow meter
Full demineralisa-
tion cartridges
with conductivity
meter
The DOS modules are equipped with a monitor which sends a mes-
sage to the washer-disinfector if the level drops below the minimum.

Water demineralisation

Two water demineralisation cartridges can also be accommodated in
the UG 70-60/80 unit, each with a meter and a display unit.
With partial demineralisation, carbonate hardness is reduced by bind-
ing calcium and magnesium ions, thereby reducing the mineral con-
tent of the water.
The flow meter indicates when the cartridge requires changing.
– TE P 2000 partial demineralisation cartridge
Filled with 12.5 l resin.
– TE P 2800 partial demineralisation cartridge
Filled with 19 l resin.
Full demineralisation removes all salts and minerals from water.
The conductivity meter shows the conductivity level of the dem-
ineralised water in µS/cm (microsiemens per centimetre) to enable
quality control of the demineralised water.
– VE P 2000 full demineralisation cartridge
Filled with 12.5 l resin.
– VE P 2800 full demineralisation cartridge
Filled with 19 l resin.
The cartridges are filled with renewable resin which can be regenerat-
ed after depletion. The whole cartridge can be sent to a regeneration
station for reprocessing.
The UG 70-60/80 unit has to be commissioned before first use and
operators trained in its use by a Miele technician or authorised per-
son only.
Please follow the operating instructions for the water demineralisa-
tion cartridges, conductivity meter, flow meter and the washer-dis-
infector, and pay particular attention to the warning and safety in-
structions regarding contact with chemical agents.
en - Guide to the appliance
35