Installation - IARP PUNTO FRESCO Gebrauchs- Und Bedienungsanleitungen

1 - INSTALLATION

Remove the packaging completely; clean the cabinet
using warm water with a 5% concentration of neutral
soap. Be sure to use a soft cloth for drying.
Warning!
Do not install the unit in open places and do not expose
it to rain.
Warning!
To lift and shift the unit, use the indented handles as
shown above. (fig.1)
a) Cabinet must be installed on a perfectly even surface,
far away from any heat source including sun rays.
b) It is fundamental for the condenser unit to be in
an airflow condition, therefore the bottom grids on
the sides, front and rear of the cabinet have to
be unobstructed by boxes or any other kind of
blockage (fig.2).
c) The good performance of the cabinet can be
compromised due to continuous air movement
(i.e.caused by fans, air-conditioned system
grilles, etc.) (fig. 2).
d) Install and position the unit in such a way so as
to allow easy access to the power socket.(fig. 2).
e) Never use electrical equipment in the refrigerated
compartment.
f) Never place containers of liquid on or immediately
above the ticket counter; should the content spill
out,it would damage the counter.
g) The cooling of the product placed inside the
cabinet is ensured by air circulation inside the
tank (see photo 1 - 2)
Thus:
- avoid to overload the cabinet (see max load
level in photo 1)
- ensure that the inner airflow grill be free from
any blockage.
THE REFRIGERATOR IS NOT SUITABLE FOR
WORKING IN DANGEROUS ENVIRONMENT
WITH RISK OF FIRE, EXPLOSIONS OR
RADIATIONS.
INSTRUCTIONS FOR THE USER
MAX LOAD LEVEL
Phot.2
INLET AIR FLOW
- 7 -
(Fig.1)
(Fig.2)
OUTLET AIR FLOW
Phot.1