urmet 1092/255H Schnellanleitung Seite 6


High-definition AHD 1080P (Analog High Definition) video output

CVBS standard interlaced video output

Video output in COMET mode
If pressing the menu access button to the RIGHT for a few seconds, you can select the AHD video output.
If pressing it for a few seconds to the LEFT, you can select the CVBS video output.
PAL e NTSC standards can be selected, besides from the OSD menu and for all video outputs, pressing
the menu access button to DOWN for a few seconds. The command works in toggle, selecting
alternatively PAL and NTSC.Pressing the button to UP it is also possible to select the video output to
720P (with reduction of the angle view).
You can enter the COMET video mode if you select an OSD menu item and if the video signal is in CVBS
(ADJUST menu).
NOTE: COMET option is available only with the CVBS video output.
The presence or absence of this option therefore permits to identify if the camera is using the CVBS or
AHD video output.

ATTENTION: in case of missing video on the connected device (monitor or DVR), check that the

video output is not set to NTSC or 1080P when you are using a DVR with 720P video inputs

In case of missing images in a DVR with AHD and CVBS inputs, try the following steps:

1. Leave a single camera connected to the channel 1 of the DVR
2. Press the button for few seconds to right and left until the image appears on the
screen
3. If case of missing image again, press the button to down verify the type of input
selected on the DVR menu
MENU USE
The camera ref. 1092/255H uses a multi-level menu that allows to enable/disable or change camera
settings. To have access to the main menu button, with the camera switched on and operating, unscrew
the front cover to gain access to camera adjustments.
Important note:

The OSD menu activation button is joystick type; it is used to make selection operations easier.
MENUS SYSTEM DESCRIPTION
Once the menu access command has been performed pressing the central button, the access first screen
will be displayed.
Displayed items can be selected by pressing the down button.
Once the item has been selected, the parameter can be changed using the right button and choosing
among the available options, that can be displayed by pressing repeatedly the button.
By selecting the item associated to the symbols
where other changes can be performed.
To quit the menu or the submenu and confirm the executed changes, select the item EXIT SAVE&END
and press the central button.
To reactivate the default values select the item EXIT RESET and press the central button.
6
or it is possible to access to the next submenu,
DS1092-216A