Herunterladen Inhalt Inhalt Diese Seite drucken

Disconnection Of The Hearing Aid; Battery (Insertion And Change); Program Button; Placement Of The Hearing Aid - Microson m4 mRIC ZERO Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 62
EN
EN

Disconnection of the Hearing Aid

See Figure 2
DISCONNECT: To disconnect your hearing aids partially open the
battery compartment.
CONNECT: To connect your hearing aids close the battery
compartment.

Battery (insertion and change)

See Figure 3
Open the battery compartment
Remove the battery cover and position it with the "+" symbol facing
up. Close the battery compartment.
i If the battery is not well-placed, the hearing aid will not
function.
To remove the battery, put the hearing aid upside down, open the
battery compartment and allow the battery to fall in your hand.
i INFORMATION
• Remember that your hearing aid warns you through four beeps
when you need to change the battery.
• Remove the batteries if you will not use the hearing aid for a
prolonged period.
• Immediately replace weak batteries.
 Do not throw the batteries in the garbage! Hand them in to
a hearing health professional so that the batteries are properly
eliminated without harming the environment.
EN
MU-0021-005-LP2-RevA.indd 16-17
16

Program Button

See Figure 4
On pressing the button, the program change will be performed
cyclically; you will hear some tones that will indicate to you in the
program it's found.
Example: (Two tones ♪♪, Program 2)
Follow the instructions of your hearing care professional to get the
most out of your hearing aids.
Each program will allow you to better adapt to the different
surroundings or situations of your daily life.
*Your hearing aids comply with standard IEC 60118-13 on electromagnetic compatibility.

Placement of the Hearing Aid

See Figures 5 and 6
1. Carefully insert the mould or the dome into the ear without pushing
it in too deeply.
2. Place the hearing aid behind the ear.
3. Check that the entire set is properly supported.
WARNING
• Do not push the dome or mould too deeply into the ear.
• Use the receiver tube and the dome or the earmold only in the way
described in this user's manual.

Change of Adapter

See Figure 7 and 8
It is strongly recommended that your hearing professional
change and teach you to change the adapters and filters, because an
incorrect replacement could lead to a potential problem: the adapter
could remain into the ear canal when the hearing aid is removed.
WARNING
Danger of injury from improper use of domes or earmolds.
17
EN
28/03/2019 9:15:39

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

M2 mric zero

Inhaltsverzeichnis