After Use; Storage When Not In Use; Troubleshooting - Silvercrest SFMT 2.4 A1 Bedienungs- Und Sicherheitshinweise

SilverCrest SFMT 2.4 A1
 Click "Restore to default" to restore the current profile settings to their
factory default values. After confirming the safety prompt, the assignment
for all buttons is restored to the default values.

8. After use

If you do not plan on using the wireless mouse for an extended period, we
recommend switching it off by sliding the On/Off switch (8) to the "Off"
position.

8.1 Storage when not in use

When left unused for a long period of time, remove the batteries from the
wireless mouse. Remove the USB nano receiver from your computer's USB
port and insert it into the storage slot within the battery compartment (10) of
the wireless mouse. Make sure that the storage temperature is maintained
between 5 °C and 40 °C. Humidity must not exceed 90% rel. humidity.

9. Troubleshooting

If, after setup, the wireless mouse does not respond, please test the
following:
 Please check the polarity of the batteries (see the chapter "Inserting the
batteries").
 Check the charge level of the batteries (if necessary, insert new
batteries).
 Please check that the receiver unit is connected properly to your
computer (see page 12, "Connecting the USB nano receiver").
 Please try a different USB port.
 If the scrolling function doesn't work, you have probably enabled the
media operating mode. Press and hold the CPI button (5) for about 5
20 - English