Installation; Maintenance - CAME MR8701 Handbuch

LED-SIGNAL
Presence
detection
LED flashes
x

INSTALLATION

The sensor should be
fixed firmly to avoid
extreme vibrations.

MAINTENANCE

It is recommended to clean
the optical parts at least once
a year or more if required due
to environmental conditions.
SAFETY
The door control unit
and the door cover
profile must be correctly
earthed.
• The device cannot be used for purposes other than its intended use. All other uses cannot be
guaranteed by the manufacturer of the sensor.
• The manufacturer of the door system is responsible for carrying out a risk assessment and installing the
sensor and the door system in compliance with applicable national and international regulations and
standards on door safety.
• The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate
adjustments of the sensor.
LED flashes LED flashes
x times red-green
Do not cover the sensor.
Only trained and
qualified personnel
may install and setup
the sensor.
LED flashes
quickly
Avoid moving objects
and light sources in
the detection field.
Do not use aggressive
products to clean
the optical parts.
Always test the good
functioning of the
installation before
leaving the premises.
LED is off
Avoid highly
reflective objects in
the infrared field.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
7