Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INTENDED USE OF THE PRODUCT
GB
-
This appliance is designed solely for domestic usage. No other use is permitted (e.g. heating rooms). To
professional use is forbidden. The manufacturer declines all responsibility for innapropriate use or incorrect setting of the controls.
-
This appliance is intended to be used in household and similar applications such as :
-
Staff kitchen areas in shops, offices and other working environments;
-
Farm houses;
-
By clients in hotels, motels and other residential environments;
-
Bed and breakfast type environments.
-
CAUTION : T
he appliance is not intended to be operated by means of an external timer or separate remote controlled supply system.
-
Do not use the appliance outdoors.
-
Do not store explosive or flammable substances such as aerosol cans and do not place or use gasoline or
other flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently switched on.
-
Do not store explosive or flammable substances such as aerosol cans and do not place or use gasoline or
other flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently switched on.
INSTALLATION
-
Installation and repairs must be carried out by a qualified technician, in compliance with the manufacturer's instructions
and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual.
-
The electrical and gas connections must comply with local regulation.
-
Children should not perform installation operations. Keep children away during installation of the appliance.
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, during and after the installation of the appliance.
- WARNING :
Modification of the appliance and its method of installation are essential in order to use the
appliance safely and correctly in all the additional countries
-
Use protective gloves to perform all unpacking and installation operations.
-
After unpacking the appliance, make sure that the appliance door closes properly.In the event of problems, contact the dealer
or your nearest After-sales Service. To prevent any damage, only remove the oven from its polystyrene foam base at the time of installation.
-
The appliance must be handled and installed by two or more persons.
-
The appliance must be disconnected from the power supply before carrying out any installation operation.
-
During installation, make sure the appliance does not damage the power cable.
-
Only activate the appliance when the installation procedure has been completed.
Kitchen units in contact with the appliance must be heat resistant (min 90°C)
-
GAS CONNECTION
- WARNING : P
rior to installation, ensure that the local gas delivery conditions (nature or pressure) are
the setting of the hob (see the rating plate and injector table).
-
Use pressure regulators suitable for the gas pressure indicated in the instruction.
- WARNING :
The adjustment condictions for this appliance are stated on the lable (or data plate).
-
WARNING : This appliance is not connected to a combustion products evacuation device. It shall be installed
accordance with current installation regulations. Particulat attention shall be given to the relevant requirements regarding ventilation.
- WARNING :
These operations must be perfomed by a qualified technician.
-
If the appliances is connected to liquid gas, the regulation screw must be fastned as tightly as possible.
-
When gas cylinder is adopted, the gas cylinder or gas container must be properly settled (vertical orientation).
-
Use only flexible or rigid metal hose for gas connection.
- IMPORTANT : I
f a staineless steel hose is used, it must be installed so as not touch any mobile part of the
It must pass thorugh an area where there are no obstructions and where it is possible to inspect it on all its length.
-
After connection to the gas supply, check for leaks with soapy water. Light up the burners and turn the knobs
from max position 1* to minimum position 2* to check flame stability.
ELECTRICAL WARNINGS
-
Make sure the voltage specified on the rating plate corresponds to that of your home.
-
For installation to comply with current safety regulations, an omnipolar switch with minimum contact gap of 3mm is required.
-
Regulation require that the appliance is earthed.
-
For appliances with fitted plug, if the plug is not suitable for you socket outlet, contact a qualified technician.
-
Do not use extension leads, multiple sockets or adapters. Do not connect the appliance to a socket which can be operated by remote control.
4
.
.
aim the appliance as
compatible with
and connected in
furniture (e.g.drawer).
Werbung
Inhaltsverzeichnis
