Preparing To Charge; Charger Location - Bahco BBCE12-F100 Benutzeranleitung

Do not use this battery charger for charging dry-cell batteries
that are commonly used with home appliances. These batteries
may burst and cause injury to persons and damage to property.
2.4 NEVER charge a frozen battery.
2.5 Consider having someone nearby to come to your aid when
you work near a lead-acid battery. Have plenty of fresh water
and soap nearby in case battery acid contacts your skin,
clothing or eyes.
2.6 If battery acid contacts your skin or clothing, immediately
wash the area with soap and water. If acid enters your eye,
immediately flood the eye with cold running water for at least
10 minutes and get medical attention right away. If battery
acid is accidentally swallowed, drink milk, the whites of eggs
or water. DO NOT induce vomiting. Seek medical attention
immediately.

3. PREPARING TO CHARGE

RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A HIGHLY
WARNING
CORROSIVE SULFURIC ACID.
3.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.
3.2 If it is necessary to remove the battery from the vehicle to charge it, always remove the
grounded terminal first. Make sure all of the accessories in the vehicle are off, to prevent
arcing.
3.3 Clean the battery terminals before charging the battery. During cleaning, keep airborne
corrosion from coming into contact with your eyes, nose and mouth. Use baking soda and
water to neutralize the battery acid and help eliminate airborne corrosion. Do not touch
your eyes, nose or mouth.
3.4 Add distilled water to each cell until the battery acid reaches the level specified by the
battery manufacturer. Do not overfill. For a battery without removable cell caps, such as
valve regulated lead acid batteries (VRLA), carefully follow the manufacturer's recharging
instructions.
3.5 Read, understand and follow all instructions for the charger, battery, vehicle and any
equipment used near the battery and charger. Study all of the battery manufacturer's
specific precautions while charging and recommended rates of charge.
3.6 Determine the voltage of the battery by referring to the vehicle owner's manual.
3.7 Make sure that the charger cable clips make tight connections.

4. CHARGER LOCATION

WARNING
RISK OF EXPLOSION AND CONTACT WITH BATTERY ACID.
NOTE: This is a Class A product for industrial use only, for use with professional equipment
with a total rated power greater than 1 kW. In a domestic environment, this product
may cause radio interference, in which case the user may be required to take adequate
measures.
4.1 Locate the charger as far away from the battery as the DC cables permit.
4.2 Never place the charger directly above the battery being charged; gases from the battery
will corrode and damage the charger.
4.3 Do not set the battery on top of the charger.
4.4 Never allow battery acid to drip onto the charger when reading the electrolyte specific
gravity or filling the battery.
• 4 •