SUHNER MACHINING GEM 12 Originalbetriebsanleitung Seite 17

d
isplAy contrAst
Repeatedly press «Exit» to switch to output mode. Press
the menu and arrow keys at the same time to set the con-
trast.
t
ime And dAte
The menu «Time and date» rovides the following options:
- Show/hide clock
- Change format
- Edit time and date
m
Achine pArAmeters
After first installation or mechanical changes, the param-
eters must first be modified.
8201 – Select spindle configuration A, B, or C as de-
scribed in the operating instructions no. 30004926. The
spindle configuration must agree with the spindle con-
figuration actually installed on the machine.
8202 or 8203 – Select the number of teeth on the top or
bottom synchronising disc as described in operating in-
structions no. 30004926. The number of teeth must agree
with the number of teeth actually installed on the machine.
8204 – Select the system of units mm (metric) or inches
for the programming. The program called corresponds to
the value entered.
8205 – This takes the acceleration in seconds. Change
this value only in exceptional cases and only after consul-
tation with your SUHNER contact.
8206 – This takes the speed in manual mode in revolu-
tions per minute. Recommended: Leave the standard
value of 200 rpm.
8207 – This specifies whether a self test is executed dur-
ing the first startup. This self test detects whether the val-
ues entered for the parameters 8201, 8202, and 8203 are
identical to the actual conditions. Recommended: Acti-
vate the self test for the first startup.
p
rogrAm pArAmeters
Programs are entered via the parameter sets 80 (for
programming in mm) or 81 (for programming in inches).
These take absolute measurements (i.e. based on the
machine's zero point) (see page 2-3).
17